UNIC C2 A16, Engine Safety, Control and Alarm Systems

Instrumentation and Automation

Engine Safety, Control and Alarm Systems

UNIC C2 A16

Product Description

Embedded engine management system composed:, -Power Distribution Module (PDM-10) capable of Monitoring of voltages, short circuit protection, EMC filter, Over-Voltage protection, Transient suppressors, power failure detection, earth fault detection, reverse polarity protection., -Main Control Module (MCM): embedded control system composed of Motorola PowerPC MPC561 controller, capable of standing high vibrations and high temperatures. , -ProAct II Digital: a rotational full-electric actuator system intended to use in the engine environment ., -Input Output Module (IOM) capable of detecting Power supply failures, short circuit detection, wire break detection, engine over speed, lubrication oil pressure and HT-water temperature., -Local Control Panel (LCP) located on the operating side composed of Local/remote switch and engine control push buttons (WCP) with Start/Stop buttons, Emergency stop button, shutdown reset button and mode selector switch. Bar-graph display WIP-11 indicating Engine speed, turbocharger speed, hour counter, lube oil pressure, HT water temperature.,

Product Ratings

WIP-11: | Power Supply: 24V DC, 1A | Degree of Protection: IP67(Front), IP20 (Rear). | | IOM-10: | Power supplies RANGE: 18-32 VDC (Nominal: 24 VDC). | Operating temperature: -25 to 85 degree C. | Processor: Motorola MPC561, 56 Hz. | Memory: 1MB typical. | Number of CAN Port: 2. | | MCM: | Power supply: 24 VDC nominal (redundant), I/Os isolated from 24 VDC supply. | Digital output load: 3 channels @ 3 Amps (to control loads, such as solenoids), and 16 channels @ 150-200 mAmps. | Analogue outputs: 6 channels @ 4-20 mA | | PDM-10 | Supply voltage: 18 - 32 V DC; | Operational temperature: -25 to + 85 degree C; | Maximum relative humidity: 95% non-condensing at 55 degree C; | Degree of protection: IP 30

Applicable Standards

Not Available / To be Updated