Oil Mist Detector Triton I OMD, Safety Units for Rotating Machinery

Instrumentation and Automation

Safety Units for Rotating Machinery

Oil Mist Detector Triton I OMD

Product Description

Triton I OMD Gear and Diesel engine Monitoring System - Oil Mist Detection Navy connected with up to 16 intelligent OMD Sensors max. via the redundant serial bus
system
Remote Monitoring Unit : 1 RMU can connect to up to 8 OMD systems
Power Supply: 24V DC
Operating Current: max. 1.5 A
OMD CU: OMD Control Unit (Z09170-00-00)
OMD CU-CANBUS: OMD Control Unit CANBUS (Z09171-00-00)
OMD RMU: OMD Remote Monitoring Unit (Z09172-00-00)
OMD CU (Control Unit):
Up to 16 OMD Sensors can be connected
Sensitivity: Alarm level adjustable in 10 steps from 0,2mg/l to 10 mg/l
Relay-Outputs: Contact load for all relays max. 60V AC, 1A, 60VA / max. 60V DC, 1A, 60W
1. Relay with 2 ground-free switch-over contacts : Main Alarm
2. Relay normally closed, opens if pre-alarm condition arises : Pre-Alarm
3. Relay normally open, closes if system recognizes no fault conditions : System ready
Wire break protection with 33 kOhm resistors (standard)
Serial Interface:
RS485 for standardized industrial, bidirectional communication
RS232 for setup and configuration
Communication Protocol:
Modbus
CAN Bus (optional)
User interface: LCD Display 240*128 dots
1 LED green "System Ready"
1 LED red "Alarm"
1 LED red "Prealarm"
OMD Remote Monitoring Unit:
OMD RMU : 1Remote Control can connect to up to 8 OMD systems
built-in alarm relays of the Remote Monitoring Unit: can be be trigger an additional alarm system
Relay-Outputs: Contact load for all relays max. 60V AC, 1A, 60VA / max. 60V DC, 1A, 60W
1. Relay with 2 ground-free switch-over contacts, usually configured as main alarm : Alarm 1
2. Relay closes if system is fault-free, opens otherwise : System ready
Wire break protection with 33 kOhm resistors (standard)
Serial Interface:
RS485 for standardized industrial, bidirectional communication
RS232 for setup and configuration
Communication Protocols:
Modbus
CAN Bus
User interface: LCD Display 240*128 dots
1 LED green "Ready"
1 LED red|"Alarm 1" (usually set up as main alarm)
1 LED orange "Alarm 2" (usually set up as pre-alarm)
Connection cable: DNV GL approved
Degree of Protection: IP65

Product Ratings

Not Available / To be Updated

Applicable Standards

Not Available / To be Updated